Multi-objective optimization design of axial-flux permanent magnet memory motor based on response surface method
Author:
Clc Number:

TM351

  • Article
  • | |
  • Metrics
  • |
  • Reference [16]
  • |
  • Related [20]
  • | | |
  • Comments
    Abstract:

    Here, the Response Surface Method (RSM) is used to optimize the structure of a new Axial-Flux Permanent Magnet Memory Motor (AFPMMM) proposed in this paper.Main influencing parameters of the motor are preliminarily determined based on analysis of the electromagnetic performance equation and Orthogonal Experiment (OE), among which, three factors including soft magnetic ratio, number of rotor poles and air gap length, are selected as the design factors of OE.Then Electromotive Force(EMF), Total Harmonic Distortion (THD) and cogging torque are determined as the optimization factors, and the RSM is used as the optimization method.The Response Surface (RS) experiment is established by using the finite element software Ansoft Maxwell and the RS design software Design Expert.The simulation parameters and fitting curves of the motor under the combination model of different design factors are obtained.Different optimization methods are combined to meet the specific design requirements in this paper.Theoretical analysis and experimental results verify the feasibility and effectiveness of the proposed motor and optimization method.Then the optimization scheme is obtained through comparative analysis of the test data.The results show that the optimized motor not only reduces the cost of permanent magnet material, but also ensures good EMF and small axial force fluctuation.

    Reference
    [1] Asko P.Design of axial-flux permanent-magnet low-speed machines and performance comparison between radial-flux and axial-flux machines[M].Lappeenranta,Finland:Lappeenranta University of Technology,2005:21-23
    [2] 林鹤云,阳辉,黄允凯,等.记忆电机的研究综述及最新进展[J].中国电机工程学报,2013,33(33):57-67,8 LIN Heyun,YANG Hui,HUANG Yunkai,et al.Overview and recent developments of memory machines[J].Proceedings of the CSEE,2013,33(33):57-67,8
    [3] 周大瑞.浅析气隙磁通可调永磁电机的分类[J].科技展望,2017,27(31):60-61 ZHOU Darui.Analysis on the classification of air gap flux adjustable permanent magnet motor[J].Science and Technology Outlook,2017,27(31):60-61
    [4] 温嘉斌,于岚.田口方法在永磁同步电机结构优化中的应用[J].哈尔滨理工大学学报,2019,24(5):64-69 WEN Jiabin,YU Lan.Application of Taguchi method in structure optimization of permanent magnet synchronous motor[J].Journal of Harbin University of Science and Technology,2019,24(5):64-69
    [5] 陈硕,汤琼,彭智俊,等.基于正交试验法优化表贴式永磁同步电机永磁体[J].微特电机,2019,47(10):36-38,41 CHEN Shuo,TANG Qiong,PENG Zhijun,et al.Optimization of permanent magnet synchronous motor based on orthogonal experimental method[J].Small & Special Electrical Machines,2019,47(10):36-38,41
    [6] 史石磊,康尔良,史桂英.扁平型永磁直线电机定位力综合优化[J].微电机,2020,53(3):33-37,54 SHI Shilei,KANG Erliang,SHI Guiying.Optimization design of a permanent magnet linear motor using finite element and Taguchi method[J].Micromotors,2020,53(3):33-37,54
    [7] Gong Y,Zhao S W,Luo S F.Design and optimization of switched reluctance motor by Taguchi method[C]//2018 13th IEEE Conference on Industrial Electronics and Applications,2018:1876-1880
    [8] 李少龙.垂直轴风力发电用轴向磁通永磁发电机研究[D].焦作:河南理工大学,2018 LI Shaolong.Research on axial flux permanent magnet generator for vertical axis wind power generation[D].Jiaozuo:Henan Polytechnic University,2018
    [9] Zhu X Y,Wu W Q,Quan L,et al.Design and multi-objective stratified optimization of a less-rare-earth hybrid permanent magnets motor with high torque density and low cost[J].IEEE Transactions on Energy Conversion,2019,34(3):1178-1189
    [10] Semon A,Melcescu L,Craiu O,et al.Design optimization of the rotor of a V-type interior permanent magnet synchronous motor using response surface methodology[C]//2019 11th International Symposium on Advanced Topics in Electrical Engineering,2019:1-4
    [11] 刘彦呈,刘伟民,郭昊昊.基于田口法的永磁同步推进电机优化设计[J].微特电机,2018,46(3):18-20,24 LIU Yancheng,LIU Weimin,GUO Haohao.Optimal design for permanent magnet synchronous motor of the thruster based on Taguchi method[J].Small & Special Electrical Machines,2018,46(3):18-20,24
    [12] 邱瑞林,华青松,史成龙.基于田口法定子冲片优化研究[J].微特电机,2020,48(2):13-16 QIU Ruilin,HUA Qingsong,SHI Chenglong.Optimization of stator lamination based on Taguchi method[J].Small & Special Electrical Machines,2020,48(2):13-16
    [13] 杜晓彬,黄开胜,谭耿锐,等.基于响应面法的永磁电机转矩多目标优化[J].微特电机,2019,47(6):20-23 DU Xiaobin,HUANG Kaisheng,TAN Gengrui,et al.Multi-objective optimization of torque for permanent magnet motor based on response surface method[J].Small & Special Electrical Machines,2019,47(6):20-23
    [14] Khatab M F H,Zhu Z Q,Li H Y,et al.Comparative study of novel axial flux magnetically geared and conventional axial flux permanent magnet machines[J].CES Transactions on Electrical Machines and Systems,2018,2(4):392-398
    [15] Zhao W L,Lipo T A,Kwon B I.Comparative study on novel dual stator radial flux and axial flux permanent magnet motors with ferrite magnets for traction application[J].IEEE Transactions on Magnetics,2014,50(11):1-4
    [16] 李念,林明耀,杨公德,等.串联永磁轴向磁场磁通切换记忆电机设计与调磁特性分析[J].中国电机工程学报,2017,37(21):6190-6197 LI Nian,LIN Mingyao,YANG Gongde,et al.Design and flux regulation performance investigation of series permanent magnet axial flux-switching memory machine[J].Proceedings of the CSEE,2017,37(21):6190-6197
    Cited by
    Comments
    Comments
    分享到微博
    Submit
Get Citation

CAO Yongjuan, FENG Liangliang. Multi-objective optimization design of axial-flux permanent magnet memory motor based on response surface method[J]. Journal of Nanjing University of Information Science & Technology,2021,13(5):620-627

Copy
Share
Article Metrics
  • Abstract:318
  • PDF: 1554
  • HTML: 0
  • Cited by: 0
History
  • Received:September 14,2020
  • Online: December 02,2021
Article QR Code

Address:No. 219, Ningliu Road, Nanjing, Jiangsu Province

Postcode:210044

Phone:025-58731025